Searching for inspection lots with a specific result

[Former Member]

Hi,

Is there a way to search for an inspection lot or point containing a specific result?

Like show me all the inspection lots where characteristic "color" is entered as "red"

thanks,

[Former Member · Accepted solution]

Hi Alper,

To get it for specific material, there is an STD report available.

Try QGP1.

Regards,

Shyamal

Edited by: Shyamal Joshi on Jan 2, 2009 7:00 PM

Or there is an other way also but for that thing you need to strictly follow the below steps, without fail.

- Go to any inspection lot (T Code QA13) where this MIC's result is recorded. Ideally UD should be completed for this lot.

- In the "Characteristic" screen click on the "Chars relevant for usage decision", so it will display you all the results.

- Now click on the appropriate MIC. e.g. click on the MIC "color".

- Now click on the Result History or "Cntrl+F9".

- A small selection window will pop-up.

- Here there will be two main selections are available, 1> with Inspection Char. and 2> with Master insp. char.

- We need to "Master insp. char." activated (GREEN)

- Now at lower part of this screen there are four sub selection tabs such as Material, Object, Inspection lot, & time are available.

- In all the tabs a check box "Selection Active" is available, deactivate it.

- As soon as you deactivate it, the selection criteria will change into Yellow colored triangle.

- Noe Execute this selection.

- It will give you the data as you are looking for.

Pls revert if there is any query.

Regards,

Shyamal

-

[Former Member · Accepted solution]

Thanks, that means i should use results history to get the inspection lot number