cancel
Showing results for 
Search instead for 
Did you mean: 

problem to run WS2RFC scenario - dont find interface mapping

Former Member
0 Kudos

hello

I have a sync scenario WS2RFC. when I run it in test envrionment it worked fine. when try to run it in PROD environment I recieve an error

... (130 lines)

I can see that I have the IM in the design. how come it doesnt have a root element? ususally it means that who try to send it, send it in a wrong format.

any suggestions will be helpfull

Thanks

Kfir

Accepted Solutions (0)

Answers (4)

Answers (4)

Former Member
0 Kudos

the problem was with url that I gave to the WSDL. there seem to be a space

Former Member
0 Kudos

again, I tried this as well and the data is transfer correctly.

is there any other suggestions?

Former Member
0 Kudos

I did the full cache refresh and it didnt work.

I read both the links and the only thing that I didnt do was to restart the j2ee (since it is production).

any other suggestions will be appreciated

Kfir

prateek
Active Contributor
0 Kudos

The problem could be with the source data. Check sxmb_moni payload before mapping and test it under test tab of message mapping and see if it is working. Make sure that the sender is sending data in correct format.

Regards,

Prateek

SudhirT
Active Contributor
0 Kudos

Hi, Try this if it works for you

also if this is not hte case then try full cache refresh at http://<XIHost>:<port>/CPACache/refresh?mode=full by PIDIRUSER. and try to test the scenario in test configuration.

Thanks!

Edited by: Sudhir Tiwari on Dec 24, 2008 2:20 PM