cancel
Showing results for 
Search instead for 
Did you mean: 

Error CO_TXT_OUTBINDING_ERROR in SXMB_MONI

Former Member
0 Kudos

Hi,

I am doing file to idoc scenario and getting following error while posting the idoc in ECC.

<SAP:Code area="OUTBINDING">CO_TXT_OUTBINDING_ERROR</SAP:Code>.

I have checked my configuration in ID and everything is working fine.

Helpful answer will be rewarded by points.

Accepted Solutions (0)

Answers (3)

Answers (3)

Former Member
0 Kudos

Hi Kunal

follow thes two SAP notes

Note 1278244 - System error in interface ServiceRequestConfirmation

Note 1284103 - System error in interface ServiceRequestConfirmation

Regards

sandeep

Former Member
0 Kudos

Hi,

Please check your configurations in Integration Directory Tools Menu --> Test Configuration.Give all the values and give some sample payload from message mapping and check.

Regards,

Laawanya

Former Member
0 Kudos

Hi All,

As i have mentioned in my first post, I have already tested my configuration in Integration Builder configuration test tool and everything is showing green.

I have also refreshed the cache but still same error is showing. Pls help.

Former Member
0 Kudos

Hi,

May be a problem in creating control record . Are you using "Apply control record values from Payload" or are you leaving the job of creating control record to XI ?

Please once have a look at this blog to get a clear idea as to when to use this option: [https://www.sdn.sap.com/irj/scn/weblogs?blog=/pub/wlg/2279] [original link is broken] [original link is broken] [original link is broken];

Regards,

Laawanya

Former Member
0 Kudos

Hi,

This is bit funny error.

Just go to receiver determination and refresh the condition you gave there. Open the condition editor and just refresh all the fields, specially which has no value mentioned in condition.

It will be solved.

Kulwinder

Former Member
0 Kudos

Hi Kulwinder,

There is no condition in condition editor.

SudhirT
Active Contributor
0 Kudos

Hi,

Check your configuration in test configuration and check if everything is ok.

Thanks!

Former Member
0 Kudos

Hi,

Delete the receive in receiver determiantion and add it again. it should work. i have faced this problem so many time.

Kulwinder