Model and Metadata JCo Destination Config in WD

[Former Member]

Hi!

I just want to ask or verify if this is a correct JCo setup:

Logical System Name: WD_APT_MODELDATA_UIP_GDC

Model Instance Logical System Name: WD_APT_METADATA_GDC

Thanks!

[Former Member · Accepted solution]

Hi

I think while creating the JCO, the names have been interchanged. If it is not giving any error if you are using them in that order, then they must be the right JCOs with just the names interchanged.

Regards,

Sunil

[Former Member · Accepted solution]

Hi Sunil,

I see I see. Aryt. Thanks a lot for that input!

[Former Member]

Hi,

May be of use for you https://www.sdn.sap.com/irj/scn/go/portal/prtroot/docs/library/uuid/c09527da-39a7-2b10-9f99-c6a007e5...

Regards

Ayyapparaj

[Former Member]

Hi,

Thanks for that link. Yup, I think the project's JCO is interchanged somehow based on the link that you gave me. To give a background, this is just a transitioned project to me and the JCO was set up in that way...

I don't know why that was the case, but when I reversed the two JCO, it gave me an RFC authorization error. However, when I interchanged the MODEL and METADATA JCO, it worked fine again.

Would you know why this is the case? I just want to verify if it is alright to interchange JCOs and ensure that the conifgurations are correct.

[Former Member]

Hi,

As you mentioned "To give a background, this is just a transitioned project to me and the JCO was set up in that way".

When you interchange they are working means, while developing it might have configured in this way.

Regards

Ayyapparaj