cancel
Showing results for 
Search instead for 
Did you mean: 

Copy from Infocube to DP Keyfigure

Former Member
0 Kudos

Hi All,

Am copying data from Infocube to DP Keyfigure using SAP Program '/SAPAPO/RTSINPUT_CUBE'

But am getting an error "Characteristic Assignment: No data copied"

Have done Characteristic assignment between Cube and DP Planning area for the following

9ALOCNO -- 9ALOCNO

9AMATNR -- 9AMATNR

Can you throw some light on this

Thanks,

Santhana.

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

Please check if the data is in the cube and then check if the characterstics of cube are included in POS of DP

Former Member
0 Kudos

Hi Sai,

1. Yes there is data in cube

2. All the characteristic is available in POS, infact if ti is not available i cannot do characteristic assignment between Cube and Planning area (source and target) in 'RTSINPUTCUBE'

Former Member
0 Kudos

normal things to check...

1. Is time series initialized for the horizon you are trying to load?

2. Have you run om17 for dp (last option on screen)?

3. Have you run a consistency of the anchors?

4. are you adjusting the mapping or using proposed mapping?

post the version of your software and sy-msgno and sy-msgid if the problem persists.

Former Member
0 Kudos

Hi Dave,

I have tried all the suggestions but still the problem persists.

The message No is Message no. /SAPAPO/MSDP_REL120

Version : SCM 5.0

Former Member
0 Kudos

Hi,

1. Make sure that the combinations that you are loading exist in both the cube and the POS

2. Make sure that there are no null values for characteristics in combination you are loading.

3. If none of these work and you are on SCM 4.1, then try implementing the note 774555