on 12-16-2008 3:08 AM
I use vl02n to input the picking quantity, but I don't know why no matter i input picking quantity is 2, 20 or 30, the picking quantity will be full pick after save. I don't know what's wrong. Thanks!
Hi,
This is because the material you are using is either in the form of rolls or skids so they cannot be taken as half or any other quantity. It will be taken as a whole. E.g. If it is a roll of paper you cannot cut the roll into smaller rolls. They have a standard size and so it will be picked by the system completely. Please check the setting of the material in material master and the Unit of measure.
Regards,
Shanu.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Portfolio,
check the item category configuration for delivery. in that there is settings for pick, you might have selected auto pick or not relevant for picking, in which case the pick quantity is not cheked and upon save is showing as directly picked
to correct the issue, you can change the settings to show as check the quantity and then do the pick in whcih case it will check for pick quanityt
Thanks
Akasha
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
91 | |
7 | |
7 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.