Vendor wise MIC Limit

[Former Member]

Dear Gurs,

Pls help me for the scenario as mentioned followed.

I have a one material. for that there is a 3 differenet vendors. for that material Length is a one MIC.but as per vendor limit is different. I don't want to use a 3 different MIC for vendor wise. Requirment is One Material, One MIC but Limit should be come in Inspection plan as per vendor.

MIC u2013 length

Vendors u2013 A,B and C

Vendor Spec for length for the SAME material u2013 10-12cm,10-18cm,10-20cm (A,B and C vendors)

For GR if vendor is B then for that Inspcection lot limit of the MIC legnth should be reflected as a 10-18 cm.

Thanks in advance for help.

[Former Member · Accepted solution]

Hi Mihir,

There are two ways to incorporate the requirement.

1. Create that much number of task list counters for the inspection plans, same as the Vendors you have. I means One Task list group counter 01 will be assigned to Material 'M' Vendor 'A', counter 02 for Material 'M' Vendor 'B', & counter 03 for Material 'M' Vendor 'C'.

2. Refer the [wiki document|https://wiki.sdn.sap.com/wiki/display/PLM/SameParameters-DifferentSpecifications]

Regards,

Shyamal

[Former Member · Accepted solution]

Hi Shyamal,

Thanks for solving problem.

[Former Member · Accepted solution]

Hi Hymnal,

In case we are creating Dependent MIC, in my inspection lot task list not got assigned. When i doing change Inspection lot, system giving message " No inspection Plan found",

Pl guide.

Are we have to Check Multiple Specifications.

Regards,

Neeraj