Barcode module width

[Former Member]

I need to define the width of the smallest Unit to 7 mm (in german: Modulbreite). How can I do this?

In the TA se73 I can change the Parameter Narrow Module Width but i don´t think that this is in mm.

Help you in advance.

I use Code128.

[Former Member · Accepted solution]

Please refer to SAP note 645158. This note will tell you how to set each type of barcode.

Edited by: Yean Nean Yong on Dec 9, 2008 2:20 PM

[Former Member · Accepted solution]

The information in this note seems to be not correct.

ein Auszug:

Parameters for Code128:

• Narrow module width

Value range: 1 to 10

This is the width for the narrowest module of a bar code, measured in pixels. It controls the width of the bar code. Value 1 generates the "narrowest", value 10 the widest bars or spaces.

Here iI can tip in values of 1 to 50. And I dont now what this exactly means. And the information in the SAP System cant also be correct, because it is that this value define the minimum of characters of the

Barcode.

It is important to say, that I use the new Barcode technologie.

Edited by: Volker Schäfer on Dec 9, 2008 2:10 PM

[Former Member]

hi ,

on se 73 wen u click on ur barcode double click on it u will get the details of ur barcode , there in unit of measurmnt , put F4 there u can check different units ..

select the one which suits u ...

regards,

prashanti

[Former Member]

I use the new Barcode technologie.

[Former Member]

Hi,

Select Se73->System Barcodes->change>Select u r Barcode->Double click on that-->change barcode width and UOM.