on 12-05-2008 3:42 PM
Hi!
I went through the configuration of IDOC to IDOC scenario (MATMAS05) in IR:Design & IR:Configuraiton.
How can I test the scenario on SAP level?
(e.g. send a IDOC from business system A)
What is the tcode therefore?
Thank you very much!
regards
Thom
Late reply,deleted.
Edited by: Sudhir Tiwari on Dec 7, 2008 8:41 AM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You can use IDOC testing tool (WE19).
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Follow the below steps:-
1) trigger the IDOC using WE19 tcode link is provided to u.
2) GO to WE02 tcode and check the status of IDOC,if its green that means IDOC is send to SAP XI, if its red then there is some problem check the status record of IDOC.
3) If IDOC is green then go to SAP XI tcode SXMB_MONI and check the message status.
U have to do the IDOC configuration for the same at R3 end. just check ur configuration.
IDOC configuration
IDOC to File
https://www.sdn.sap.com/irj/sdn/wiki?path=/display/xi/sapR3%28Idocs%29ToXI--Steps+Summarized&
Wat is WE10 tcode is for? i dont think there shud be any WE10 tcode in SAP.
chirag
Hi!
Thy IDOC type is MATMAS.
Is there any possibilities to resend "yellow" IDOCs from business system A to XI?
Other question:
I cannot detect my IDOC communication channel deifned in IR:Configuration?
Should this one be visible in RWB --> Adapter Engine --> Communication channel?
Thank you very much
Thom
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.