on 12-02-2008 12:48 PM
Dear All,
Product Interchangebility is not happening???durring Heuristic RUN.??
Done all setting for the ---Predessor & successor product?
But the Base Unit of measure for succesor is PC and for Predessor is TEN?
Plz help me out to perform the same
Regards,
Rajesh Patil
Hi Rajesh,
Check
-SNP profile(img): product interchangability is made active
-IC group you created is made relevant for planning and/or planning and atp.
-IC is assigned to active model
-IC is in released state (the green flag)
-Successor product is also included in the CIF. If its an APO only product no issue then.
Check that macros are adjusted/correct if the above key figures are inserted in the dataview
Also be careful abt UoM conversion settings maintaind in product master Vs UoM of planning book Vs. 1:10 or 1:1 interchangability. I mean reconcile UoM at all these levels so that results are not confusing.
Regards,
Lok
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanks..
the same i have done..
I mean the demand from Product A is Transfering to Product B while heuristic run but the unit conversion is not happening? Ratio of A : B is 1:10
BUom A - TEN
BUoM B - PC
and 1 TEN = 10 PC.
But the while substitution demand of A is Transferd to B = 1 .??? expecting 10 and should show in Alternative UOM too.
Plz help
Rajesh Patil
User | Count |
---|---|
8 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.