How do I configure my ports?

[Former Member]

Hi there

I have a File to Idoc scenario which is configured fine and all but the sxbm_moni comlaines about a port 8000 in idx1 which gives errors. When I go to SM59 and tests the RFC's I get not problems. Does any one know what this might be and how to fix it?

Thanx,

Jan

[Former Member · Accepted solution]

HI

You need to maintain the port format for the R/3 system is SAPXXX.

Regards

Goli Sridhar

[Former Member · Accepted solution]

Could you explain a bit more in detail? Im not to down with the basis side of XI. The format I have here is lik SAPECD999 of SAPXID150 and so on.. Not sure what you mean.

[Former Member · Accepted solution]

Jan,

Please refer below link for details about Idoc ports!

Facts about IDoc Ports in XI

https://www.sdn.sap.com/irj/scn/wiki?path=/display/xi/factsaboutIDocPortsin+XI

Regards,

Jilan

[Former Member · Accepted solution]

Hi Jan,

While creating the port for R/3 System in XI you need to follow the naming convention.

That is it should be SAPXXX where XXX is the SID of the R/3 System.

You can go throgh these docs, it may help you.

https://www.sdn.sap.com/irj/sdn/go/portal/prtroot/docs/library/uuid/d19fe210-0d01-0010-4094-a6fba344...

https://www.sdn.sap.com/irj/sdn/go/portal/prtroot/docs/library/uuid/cdded790-0201-0010-6db8-beb9bb2b...

Regards

Goli Sridhar

[Former Member · Accepted solution]

Thanx for the help. I solved my problem. In my receiver IDOC comm channel the port there was set to 8000. I was not aware that I needed to make that the same as the RFC I have in SM59. Changed it and it worked.

[dharamveer_gaur2]

Hi

Have u maintain Port for IDoc

I think this is related to your HTTP port(Not Port for IDoc).

Check your HTTP port in SMICM->Service->here look your HTTP port no.