problem printing in SAP

[former_member763005]

The status of the spools is '-' .I have checked in the users profile that output immediately option is enabled.But still the spools go into thhis stsus.Any inputs to how to print these spools.?

[Former Member]

Check SPAD

Check printer Setting are correct i.e. it is sending request in proper format

if the job is big & depending on configuration it'll take time.

[Former Member]

Hi Balaji,

You should take note of the following:

1- The device type you have set must be correct.

2- Choose the correct printing mode .. i.e. F, G, L, etc.

3- Try accessing the printer (if remote) for example:
printserver : Sometimes it is not accessible if its asking for an authentication at OS level.

Regards,

Muzammil

[Former Member]

Which access method have you used to configure your printer ? Frontend Printing , Local printing ? etc

[Former Member]

 The status of the spools is '-' .

This means that the Spool request has not yet been sent to the host spool system (no output request exists)

Reference :

http://help.sap.com/saphelp_nw70/helpdata/en/78/4d22426adddf2ce10000000a1550b0/frameset.htm

Are you sure that the output device assigned/used by the user is properly configured? Is it for that user alone or for all the users using that output device?

Cheers,

Jazz