Use of both Numeric as well as Alphanumeric characters in the same section

[Former Member]

Dear All,

while creating coding mask,system is not allowing to use Numeric as well as Alphanumeric characters in the same section of the coding mask.

Is there some way by which it can done?

Regards,

B P Singh

[Former Member]

This is standard system behaviour.So nothing can be done.

Regards,

B P Singh

[nitin_patoliya]

Hi

Please check what you have customised in OPSJ ( Chage view Project no editing )

In OPSJ in coding maks filed you have to use X if you want to use alphaneumeric project coding mask.

You can code the project definition according to various criteria in order to,

The characters in project editing are masked as follows:

"X" stands for alphanumerical characters

"0" stands for numerical characters

Regards

Nitin

Edited by: Nitin Patoliya on Nov 27, 2008 11:22 AM

[Former Member]

Hi Nitin,

system is allowing that it should be either

T-XXXXX-

or

T-0000-

My requirement is

T-000X-

I hope the requirement is clear now.

Regards,

B P Singh

[nitin_patoliya]

Singh,

I am clear about your requirement now. But please tell me what type of error you are getting . Because after your reply I tried to creat the project in trial sys. i was able to create with zzz/ 000/c.

Please check your customisation In OPSK as well. .

Regards

Nitin

[Former Member]

The error is below:

Only numerical or alphanumerical characters may be used in each section

Message no. CJ607

Diagnosis

When coding one section you have entered both numerical and alpha- numerical characters. This is not allowed.

System Response

Processing stopped.

Procedure

For each section in the coding, enter either numerical or alpha-numerical characters.

Regards,

[nitin_patoliya]

Singh,

I am tried to get similar error, I could got the similar error while defining Project numbering editing in OPSJ.

In OPSJ in coding mask filed should use T-000-X- but ,

your are trying with T-000X- ( system will give surely error when you are not seperating numeric (0) and alpha numeric( X) values in maks. It 's standard behaviour )

I have created project with this settings. ( T-000-X). with T-000-X maks your requirement will satisfy.

Also please make sure that - ( hyfen) special characters should you have defined in OPSK.

I believe it will slove your problem.

Regards

Nitin

Edited by: Nitin Patoliya on Nov 27, 2008 1:42 PM

[Former Member]

This is the standard system behaviour.

suppose if you want project code as T-00A.

then instead of defining project coding mask as T-00X, which system will not take.

Define it as T-XXX

Then you can create your code as T-00A, T-01B,T-11C...T-00X and so on.

This is the only solution i suppose to be there.

Regards,

Nitin Ghadge

[Former Member]

thanks a lot Nitin.