on 11-26-2008 3:08 PM
I'm trying to valuate an inspection point using RFC QIRF_GET_INSP_POINT2 with record type (SATZART) Q84 and get the error message QT 415 "Batch( ) and/or partial lot( ) in QAIPP(´...) is incompatible with TQSS1" where the dots stand for the material number. I found no explanation for the cause of this error.
Any suggestions ?
Kind Regards
Matthias Breuer
It was a quite simple mistake I made. I left the partial lot number (TEILLOS) empty, because the inspection point does not support partial lots. I tried the RFC QIRF_GET_INSP_POINT2 from SE37 transaction and it works. The difference is, that SE37 fills the partial lot number with '000000'. So I changed the LIMS interface to fill the partial lot number with '000000' and now it works. The inspection points are valuated either by uploading an explicite valuation code or by sending no valuation code when in the operation the inspection point completion is set to automatic valuation based on inspection point definition.
Thanks to SE37
Kind Regards
Matthias Breuer
Edited by: Matthias Breuer on Nov 28, 2008 9:38 PM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
103 | |
14 | |
10 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.