which software component should I use if want to implement a IDOC-to-IDOC

[Former Member]

Hi all:

Could you please tell me which software component I should use if want to implement a IDOC-to-IDOC ?

Thank you very much!!!

[dharamveer_gaur2 · Accepted solution]

Hi

You can use any Software Component to Create IDOC to IDOC scenario, It your wish.

In case PI7.0 you have to design your scenario in Software Component where u imported IDOC.

If you are using PI7.1 then Imported Object(IDOC) can be used in any Software Component.

[Former Member · Accepted solution]

yes, I create one under one sc. but when I want to create a communication channel in ID, it is found that no interface is for the business system. the interface I have created in IR.could you please tell me how to make the interface available ?

[Former Member · Accepted solution]

Hi,

Check this:

http://www.saptechnical.com/Tutorials/XI/IDocToIDoc/page1.htm

Its the whole IDoc to IDoc scenario

Thanks,

Mahi

Edited by: Maheshwari Morbale on Nov 25, 2008 4:36 AM

[Former Member · Accepted solution]

do the following

1) Associated the software component to the Product.

2) Associate the product to the business system created

then create the communication channel... you will see the interface..

[Former Member · Accepted solution]

could you please tell me in detail how associate the software component to the Product and associate the product to the business system created?

Thank you very much!!!

[dharamveer_gaur2]

Hi

Also use this Blog to Create TS,BS and Product assigning.

[dharamveer_gaur2]

Hi

Use this document to Create technical System and Business System during this u will assign Product and Software Component.

use this blog steps

http://help.sap.com/saphelp_nw04s/helpdata/en/87/7277e8fba34421a45d97a41ec27381/content.htm

http://help.sap.com/saphelp_nw70/helpdata/en/24/8fa93e08503614e10000000a114084/frameset.htm

After Creation of BS, import into ID using right click on Configuration Scenario and assign using wizard.

After that Click on BS and then assign your Interface using Sender and Receiver Tab.

[dharamveer_gaur2]

hi

Have you assigned Your interface to BS in ID?

[Former Member]

use anything u like to. There is nothing restriction.