CCMS Monitoring Sets in SAP Netweaver ABAP 7.01 Trial

[valeriocicchiel]

Hi community,

I have successfully installed the trial in the subject but I can't see the alerts in transaction rz20 under CCMS Monitoring Templates. If I click on a node the message "No alerts data exists" appears in the status bar

I am not an expert of these functionalities, but I suspect that they have been disabled in this trial edition. Am I right, or I have to do some post actions to activate it?

Thanks, Valerio

[former_member366527 · Accepted solution]

Hello Valerio,

in the SAPMMC console, where you start your NSP instance, you have also possibility:

Open Alerts

Syslog

Peter

[valeriocicchiel · Accepted solution]

Hi,

this is true, but these are disabled (in gray color) and the alert tree is empty, because these graphical icons reflect the status of monitoring alerts.

I found that parameter alert/MONI_SEGM_SIZE was set to 0 in the instance profile

By setting it to 40000000 (minimun value) now I can see the alerts in SAP MMC and the tree of alerts is full.

Unfortunately if I go in transaction RZ20 i see nothing as before...

Regars,

Valerio

[former_member366527 · Accepted solution]

Hello Valerio,

as I am developer, I have never occupied myself too deep

with monitoring. But my preview installation is working

already months without problems. My alerts are too full of messages in MMC.

Peter

[valeriocicchiel · Accepted solution]

Hello Peter,

I found the answer to my question in this post:

[;

Thanks,

Valerio