SDP94 default in display mode when loading a selection

[Former Member]

Currently our SDP94 transaction defaults to change mode when loading a selection into the planning grid. Is there anyway to change this to display versus change?

[keiji_mishima · Accepted solution]

Hi Stacy

You can change default mode by using BADI.

BADIv/SAPAPO/SDP_INTERACT

Method DVIEW_DISPLAY_MODE_SET

The display/ change mode can be altered for specific users with

Also for specific user, user parameter is available.

the user parameter '/SAPAPO/SDP94_D_MODE':

- '''I''' (Initial)

TA SDP94 started in display mode, switch to change mode possible

- 'A' (Always)

TA SDP94 started in display mode, switch to change mode not possible

- '''C''' (Change)

TA SDP94 started in change mode (if the planning book/ data view permits the change mode)

More detail information is described in Note 401830. So I recommend you to read this note.

Best Regards

Keiji Mishima

[Former Member · Accepted solution]

Thanks Keiji! Your answer is very helpful!