on 11-18-2008 12:44 AM
I try to create the new communication channel . I have all the parameters but adapter engine does not show any parameters in dropdown.
In the parameters tab I have the following:
Adapter Type : File
Transport Protocol: File System(NFS)
Message Protocol: File
Adapter Engine: << Does have anything in the dropdown>>
Hi
Perform these action as in my previous reply.
use SLD refresh and Refer OSS Note 764176
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Go through the doc.. refer page 19 and 20.. Check if the steps are followed.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI satyanarayana devathi
Somthing is not configured correctly in SLD.
As specified in Weblog can u check once again.
the technical system and business system were not created in SLD for XI server.
OR
The technical system and business system were not created properly in SLD for XI server.
Also
Can u refresh the cpa cache,
also can u run SLDCHECK tcode and check the result
chirag
User | Count |
---|---|
91 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.