MIC Tolerance Specification

[Former Member]

Dear All,

I have to use the tolerance of characteristics 20X12 +0.05 mm but system is throwing an error message Value can't be interp. as floating-point number or longer than 22 charac.

how to set the tolerance as mentioned above?

Regards,

Anil

[Former Member · Accepted solution]

Hi anil,

Create Quantitative MIC with incomplete copy model and check control indicator Documentation required. Assign MIC in inspection plan and maintain No of decimals as 4, Unit of measure as mm2, Lower limit as 240 (i.e. 12 x 20), Upper limit as 241.6025 (i.e. 12.05 x 20.05) and in the long text of MIC maintain specification as 12x20 to 12.05x20.05.

At the time of RR, Enter the value, which you get after multiplication and maintain actual size at Inspection short description for the MIC.

Hope this solves your problem.

Check it with the client. I think you have no other option.

Regards

Venkat.V

[Former Member · Accepted solution]

Hi Venkat,

Thanks very much for the reply.

Good logic to work on.

I will try out and check with the client.

Points has been awarded for your valuable suggestion.

Thanks once again.

Regards,

Anil

[anand_rao3]

Hi Anil,

Can you make two separate MICs. I mean to say '+20X12 +0.05+' can be interpreted as 20 0.05 and 120.05

Anand Rao

[Former Member]

Hi Venkat and Anand..

thanks for your replies.

well, My client doesn't want to make it into two mics as the characteristics is 1 and not interested to maintain for 2 characteristics.

If there is any alternative then pl revert.

Regards,

Anil

[Former Member]

Hi,

System canu2019t interpret 20X12 + 0.05, use only numerical values.

regards

Venkat.V