File to Idoc scenario

[Former Member]

Hello,

I have problems sending an Idoc to r/3

The scenario is as follows.

A file is received in XI. The sender is a business service with party (no business system).

The file is converted to Idoc and send to R/3.

The sender of the Idoc is not a logical system (LS), but a partner with type LI.

I get the error that the sending service cannot be converted to an ALE logical system.

But I don't have a logical system as a sender.

So my question is how I can fill the Idoc control record with a partner(number) and type LI.

I already entered an alternative partner in the settings of the sending party in ID (under identifiers).

But I think this isn't enough.

Can anyone help me with this ?

Regards,

Marco van Iersel

[MichalKrawczyk · Accepted solution]

hi Marco,

the document below explains how do do LI

in receiver idoc adapter

https://websmp104.sap-ag.de/~sapdownload/011000358700003604082004E/HowTo_IDOC_XI_Scenarios.pdf

have a look at points 5.2 for instance

Regards,

michal

[Former Member]

Thanks for the quick answers.

I've got it worling now !

The problem was that I didn't change the communication channel, tab identifiers. Here I filled the sender (serivce with party) and receiver (R/3 business system).

Thanks a lot!

Marco

[sam_raju]

Hi Marco,

Make sure you have the following things defined in your configuration.

1)Sender Party

Identifier: Same as the Business System for Back end R/3

Scheme: ALE#<Partner Role>#<Partner Function>(for example ALE#LI#LS

Identifier: Partner Number ( same as in R/3 partner Profile)

2) Idoc Communication Channel

Make sure you check the option " Apply control record values from payload".

Identifier Tab of IDOC CC

Make sure you specified the identifiers as shown below

Sender: R/3 Business System

Schema: AlE#<Partner Role>#<Partner Function>

Sender: R/3 Business System

Schema: ALE#LF

Hope this helps.

Regards,

Sam Raju