CTS failed with error message "Object was repaired in this system"

[Former Member]

CTS got failed with message "Object was repaired in this system".

I checked the object in source and destination system to find if there any CTS holding up this object however I could not find any CTS.

Can anybody know what woould be the way -forward.

[rkresha]

I too was having this problem, and was unable to find a request with the object in it.

Here is the fix that I used:

TCode: SE03

Under the "Transport Organizer Tools" > "Objects" > "Display Repaired Objects"

If you go into "Display Repaired Objects" it should show you a list of repaired objects and all you have to do at this point is to click on the object that the system is complaining about and click the "Repair Flag" button above it and this should reset the flag and allow you to continue on.

I had this problem on Object "R3TRFUGRSMSY_GROUP_INTERFACE"

Hope this helps everyone else that is stuck on this error message.

-Rob

[Former Member]

Hi Rob,

Even I am facing the same problem while importing an SP.

In se03 i could see one class and one function group as reqpaired.

I just want to know what will be the changes that happens in the background if I click on the Repair flag button.

Thanks in advance!

Abhilash

[Former Member]

If transport ended with the error message "you mentioned "

do the following run TX se03

search for objects in request/task

selection of objects put the name of the object

and also check the find sub-objects, modifiable and realased

The system will find all request with the object, you have to find such one, which is in the status Modifiable and release it.

But discuss this with the owner of the Modifiable request if you can realese his task.

Peter