cancel
Showing results for 
Search instead for 
Did you mean: 

problem in tms configuration

Former Member
0 Kudos

Hi,

I have installed development DEV and quality QAS and trying to set up a transport path from DEV to QAS.

DEV is the domain controller.

I approve the QAS system in DEV but then in configuration status for QAS is shows "adjust configuration"

The configuration is not up to date.

From DEV if i run update configuration selecting QAS it executes successfully but the status remains the same.

Now in QAS system I run update configuration selecting QAS, it shows : No valid system specified (QAS)

-


System DEV Command TMS_MGR_TRIGGER_DISTRIBUTION

Client 000 Service Configuration Service

User BASIS Start Online

Date 07.11.2008 Function TMS_CFG_START_DISTRIBUTION

Time 16:27:20 Message SYSTEM_NOT_ALLOWED

No valid system specified (QAS)

-


Please suggest.

Regards,

Amit

Accepted Solutions (0)

Answers (4)

Answers (4)

Former Member
0 Kudos

thanks

Former Member
0 Kudos

I am trying to set up transport route from DEV TO QAS.

DEV is the domain controller.

Then while configuring TMS in QUA I include that in domain dev and approve it from the system DEV.

But after approving its showing the configuration is not up to date

I distributed the configuration from DEV system but the status remains the same.

Then I tried to update configuration from QAS

it pop ups an error message "No valid system specified (QAS)"

The below is the error message pop up

System DEV Command TMS_MGR_TRIGGER_DISTRIBUTION

Client 000 Service Configuration Service

User BASIS Start Online

Date 07.11.2008 Function TMS_CFG_START_DISTRIBUTION

Time 18:49:04 Message SYSTEM_NOT_ALLOWED

No valid system specified (QAS)

I have deleted the TMS config several times and tried to reconfig through se06 and stms but no luck.

Former Member
Former Member
0 Kudos

yes, when i do that in the qas system it thorows the error message

No valid system specified (QAS)

former_member1283182
Participant
0 Kudos

from which client are you configuring it?

could you plz write the steps you followed...

Regards,

Satish.

JPReyes
Active Contributor
0 Kudos

Go to STMS -> System Overview in you QA system and click on SAP System -> update configuration... that should pull the info from the domain controller.

Regards

Juan