Payload is missing in XI adaptor

[Former Member]

HI

My scenario is file->XI->Proxy.

Message is showing sucessful in SXMB_MONI,but the output message in payload of XI adaptor is not comming.Under the SOAP Ody only maifest exists,ut no payload can be seen.Also in proxy input structure data is not comming(initial).What can be done??

Thanks

Debraj

[udo_martens]

Hi Debraj,

your trace is too low.

Transation SXMB_ADM / Configure Integration Engine / Specific Configuration

Category RUNTIME / Parameter TRACE_LEVEL should be 3 (full trace)

Parameter LOGGING should be 1 (trace switched on)

Regards,

Udo

[Former Member]

Hi Debraj,

Have you checked if the queues in Application System are registered ?

You can go to SXMB_MONI transaction in the Application System(on WAS 620 ) and check if your message is stuck over there.

Hope this helps.

Regards,

Sulakshana

[Former Member]

Hi debraj,

Is your XI patched upto SP15?

if so then, the payload doesnt appear in the SXMB_MONI transaction code. There was no clue to this behaviour. There are also some threads that discussed this.

Go thro these threads,

regards,

P.Venkat