Communication channel not found:

[Senthilprakash1]

Hi all,

I created a scenario and activated the entire scenario.

Now when i went to Communiication channel monitoring. *I am not able to see the communication channels i have created.

Hence i am not able to Start them.*

Please Advice

Regards,

prakash

[Former Member · Accepted solution]

Hi,

Check wether u can see in u r RWB.

Do Cache refresh as said and try to run the scenario when u r sure that u have craeted th CC and see watz happening in SXMB_MONI and the CC Monitoring

lemme kmnow

rgds

srini

[former_member200962]

Hi,

Please do the following:

1) SAPGUI -- sxi_cache -- CC......here you fill find all the CC corresponding to your respective Business Service.

3) Do a Delta Cache refresh......complete may not be favourable.....

2) Check if there is any error in ID -- Environment -- Cache Notification...

3) Go to RWB -- Component Monitoring -- Cache Connectivity Test....you may find an error here (if there is any)

4) Please check if your channel is properly configured in the Sender/Receiver Aggrement.......you can even run the configuration wizard once more if you want.....no harm with that....

Regards,

Abhishek.

Edited by: abhishek salvi on Nov 7, 2008 10:37 AM

[Former Member]

Hi,

Can you do XI runtime Cache refresh:

Transaction : SXI_CACHE

from the menu, do delta and full refresh

and CPACache refresh:

http://<server:port>/CPACache/refresh?mode = full

Regards,

Sreenivas

[samiullah_qureshi]

Hi,

Check your adapter engine is in RWB under component monitoring.

Also do Complete CPA cache refresh using following URL: -

http://<host>:<port>/CPACache/refresh?mode=full

Regards,

Sami.

[dharamveer_gaur2]

once do Full cache refresh and check again

[Former Member]

HI,

What is your sceanrio? If you created any channels for IDoc then you can not findout those channels in the RWB.

If adapter engine is up then do the full cache refresh and see the in the RWB

Regards

Sridhar Goli

[Senthilprakash1]

Source and destination are FILE ADAPTERS.

I am able to see the Business Service created. But i am not able to see the CC's.

I am not able to start the Channels becase of this problem,

Please Advice.

[dharamveer_gaur2]

Check your Adapter Engine is working fine.

[Senthilprakash1]

yes Adapter engine is working fine.