Exporting a Model from Shared Repository

[Former Member]

Hi,

I wanna take a copy of a model from the shared repository.When i use save as option, it saves the model in the local repository dcs.Then i tried to export the model from there.but it gives the below error

"Cannot export the model because its referenced components have not been saved in the local repository"

can anyone tell me the solution?

Thanks and Regards,

Priya

[Former Member]

Hi Pryia

There is a way of doing this, but it may require some manual work.

What you have to do is save your model to the local repository, then save all the models it depends on (other models can be used as nested models or as go-to links).

Last (and most tedious) thing to do is to delete all the data services from your model, re drag them into the model from the search panel and re-wire them.

This is not such a good solution, and it will be much easier to do in the next version (7.1.1), but currently this is all I have to offer.

Regards,

Shai

[Former Member]

Hi Shai,

Thanks for your Reply.It works but takes a long time to delete all the dataservices and rewire them.

[Former Member]

Hi Priya

This issue is already fixed in VC7.1.1 which should be available soon.

Regards,

Shai

[Former Member]

Hi Priya,

yes this is a Limitation

see the Below SAP note no: 1042312

[https://www.sdn.sap.com/irj/servlet/prt/portal/prtroot/com.sap.km.cm.docs/oss_notes/sdn_oss_ep_vc/~form/handler]

Govindu

[Former Member]

Hi Priya,

the model you are working with is using other models or data services. These models must be saved to the local repository. After saving that you must re arrange the references for pointing to the referenced model in the local repository. I think that after that you can export your model.

Read page 44 of Visual Compser for SAP Netweaver Composition Environment Modelers Guide and Reference Guide: http://help.sap.com/saphelp_nw70/helpdata/en/42/c2ba85545e3116e10000000a1553f7/frameset.htm

Hope this helps

Regards

Fernando

[Former Member]

Sorry, this is the correct link : http://help.sap.com/saphelp_nwce10/helpdata/en/45/04134e8a5741dee10000000a1553f6/frameset.htm

the other one points to 7.0

Regards

Fernando