error while updating SP's for Solman

[Former Member]

Hello ,

I am updating the SP's for Solman. and I have come across these 3 errors, how do I resolve them

1.Function RSDDTREX_INDEX_CHECK (RSDDTREX_CHECK 01) does not fit into the existing function group ((RSDDTREX 06))

2.Table RSBGUI_R_TEST is not in nametab.

3. Phase ADDON_CONFLICTS_?: Explanation of Errors

Conflicts were found between the Support Packages that you want to

import and the Add-Ons installed in the system. To guarantee the

consistency of your system, the import is interrupted until all Conflict

Resolution Transports (CRTs) for the listed Support Packages are

included in the queue.

To include the CRTs in the queue, proceed as follows:

#NAME?

- Leave this screen by choosing 'Cancel' (F12).

#NAME?

Service Marketplace or request them from your Add-On supplier.

#NAME?

#NAME?

the beginning.

If the problem involves an SAP Add-On, see SAP Note 53902, which tells

you which CRTs resolve the conflicts. Otherwise contact the supplier of

your Add-On for details on how to proceed.

The following contains a table of Support Packages for each Add-On for

which conflicts were detected. The column 'Information on the Conflict

Resolution' specifies how you can resolve a conflict. For more

information, select the corresponding 'Information for the Conflict

Resolution'.

Note:

You are importing the queue in the test scenario. As this scenario is

only used for performing analyses, you can skip the errors and continue

the import in the next phase.

In the standard scenario, however, note that the errors have to be

rectified before importing can be continued in the next phase.

Conflicts Between Add-On ST-SER 700_2006_1 and Support Packages

Component Release Support Package Information onConflict Resolution

ST 400 SAPKITL425 CRT: DUMMY

Thanks Druva

[Former Member · Accepted solution]

Go through this note 662441.

What support packages are you applying?

Three errors looks completely different.

[Former Member]

Hi,

I am not sure but if you are able to reset the queue then reset the queue by deleting them from the Display/Define and As per the Note download the relevant CRT and include that CRT in the Support Pack queue. It will resolve the problem.

V....

[Former Member]

Hi there,

Thank you cauz I did get some lead into the issue with your response.

I missed on some ST's which did give me a CRT error and I downloaded them and the problem is fixed now.

I have another question in my new post please have a look at it.

I am closing this thread.

Thank you

Druva