Release does not work with product and location selection

[Former Member]

Hello everyone!

We have this problem when we try to execute the demand release from DP to SNP.

In the transaction /SAPAPO/MC90, we choose a product and we have executed the release. The return message says that there is no CVC valid. But the CVC exists. We can see it in the planning book.

If no selection is made, the release is executed correctly, but if we select product and location the message /SAPAPO/TSM230 is displayed. The same occurs if we select only the product. If only the location is selected, the release is also correctly executed.

Does anybody knows something about this?

Best Regards

LHM

[Former Member]

Please check below OSS note :

596381 Product number without leading zeros in DP-SNP release 18.02.2003

432938 Release n SNP: No plannable characteristics combination (2) 10.09

Also run below consistency check :

/SAPAPO/TSCONS - Consistency Check for Time Series Network

/SAPAPO/PSTRUCONS - Consistency Check for Planning Object Structure

Manish

[Former Member]

Hello Manish

Our version is the 5.0.

We´ve executed this consistencies check and no problem was found.

Thanks

LHM

[Former Member]

I believe you need to raise an OSS message

[Former Member]

This issue can be due 3 reasons:

1)The product InfoObject used in /sapapo/mc90 screen has default length < 40 and no conversion routines defined,

2)the usage of leading zeros is automatically set in the system,

3)the product name is a numerical value

Please check if you have any one of the above reasons.

[Former Member]

Hello Sai

Answering your comments

1) Yes, it is less than40 characters long but has conversion routine MATN1

2) Yes, it is set to automatically fiil with extra zeros

3) Yes, it is a numeric field

Thanks

LHM

[Former Member]

Hi LHN,

Please refer the thread for the same issue,

Manish

[Former Member]

It could be a program error if the product has leading zeroes. What SCM version are you in?. Please check OSS note: 432938

[Former Member]

Hello LHM,

Please re-intialise the POS and Planning area and try again.

Thukral