Inspection Plan Deletion

[Former Member]

Hi,

We are trying to change base unit of measure of the material. There is no transaction or any document available for this material. Only inspection plan was created but that also deleted. Still system is showing the error for inspetcion plan.

We checked table entry MAPL for material assignment to inspection plan. It is showing material assignment to group. But as checked in group with group counter it shows no assignment.

Even we checked with transaction QP60 it shows the assignment as deleted.

Please suggest the solution.

Regards,

Surinder

[dhaval_choksi3 · Accepted solution]

Hi Surendra,

As you said Entry is still exist in Table MAPL then you must have to delete the same from Table also.

To delete it from Table itself below are the steps.

- Go to SE16N.

- Enter Table MAPL and press Enter.

- Select group and counter No. It will filter unnecessary data.

- Now in Command window , Where we type the transaction codes.Write &SAP_EDIT and press Enter.

- It will issue a Massage below

SAP editing function is activated

     Message no. WUSL111

- Now Table is activate edit.

- Now execute (F8)

- Delete the material Assignment from here also.

- Save and now try to change the UOM in the material Master.It works.

Regards,

Dhaval

[Former Member · Accepted solution]

Dear Dhaval,

Thanks for prompt reply. But SAP_EDIT is not working. We are strictly following the steps given by you.

Regards,

Surinder

[Former Member · Accepted solution]

Thank you Dhaval. We could do it. I am rewarding you points.

[dhaval_choksi3 · Accepted solution]

Hi Suerender,

Write & just before the SAP ( You have to enter &SAP_EDIT in that space for T.code )

Regards,

Dhaval