on 10-15-2008 7:40 AM
Hi All,
I created a SPC chart with specification limits enabled. If user has provided lower spec limits without upper spec limits then it is taking the upper spec limit value as 0.0 by default. I would like to have limits to be one-sided.
For example:
An attribute should be at least 232,if its lower we have a problem. But there's no upper spec limit on it. The higher number we have the better.
If I put a very high number on the query, like 10000, that disturbs the Y-axis scale and shows Y-axis 0-10000, which does not show a good picture.So we need a way to enable only 1 spec limit, and keep other disabled as need.
Hoping to get a answer for this.
Regards,
Ravi Kumar
What happens when you make the upper and lower the same?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
8 | |
4 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.