10-14-2008 10:16 AM
Hi Chaps,
I am trying to install devices with eg34 with batch input, but the device has 22 registers and by installing it, the batch input has to scroll. This cause problem, do you have any experience with this?
thks
Vincent
10-14-2008 12:10 PM
Hi,
This is a genreral issue when doing a BDc recording for table control.
The scroll doesnt get recorded.
Instead do the page down(P+) event as this gets recorded and then based on the no of lines visible in the table control while recording, do a page down and enter the data while filling the BDCDATA table...
This will solve the issue
Regards
Shiva
10-14-2008 12:10 PM
Hi,
This is a genreral issue when doing a BDc recording for table control.
The scroll doesnt get recorded.
Instead do the page down(P+) event as this gets recorded and then based on the no of lines visible in the table control while recording, do a page down and enter the data while filling the BDCDATA table...
This will solve the issue
Regards
Shiva
10-16-2008 11:41 AM
Alternatively you can use BAPI: BAPI_EQUI_INSTALL . If this does not work try using FM: EQUIPMENT_INSTALL.
Personally, I would recommand FM over BDC
-ASB
10-23-2008 2:06 PM
11-28-2008 1:13 AM
Hi,
How did you solve this? Did you use FM: EQUIPMENT_INSTALL. or continued with your BDC?
Can you paste the scroll logic?
Pls answer.
thanks
Dan
12-03-2008 1:04 PM