on 10-14-2008 7:18 AM
Hi All
While loading data into PSA, I am getting an error message.
Error 4 in update.
I understand that this is an error message for SID.
But I am not able to see any other message than this.
So , I am confused, how to make out which master data to load.
Kindly help.
Regards
Hi
Goto details tab.
Expand the erroreneous data packet
check both in proccesing and update
If you are not able to see the error there, then
Go to PSA button that you can see in the monitoring screen of the IP.
select the data packet which is having error.
selesct only erroreneous records.
Now in the psa double click the sysmbol you get for error recods.
It will give the error message.
Copy the message, and hence you will know for what value it is failing.
Then you can proceed normally with the steps of solving sid
Hope this helps
Regards
Shilpa
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Kalpana
Thanks for the input, but this time it was an SID issue only.
Hi Debjani, this is what I asked, how to know which master data to load.
Hi Shilpa
Thanks!! I got to know the error.
I am closing this thread
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Even I faced the same problem "Error 4 in the update"..
in this case it might be due to duplicate records...
u can see this error in details tab of the Infoppackage...under some failed packet...
to avaoid duplicate records into the data targets.. in the settings of the IP..under the processing tab.. select the option.
Only PSA --> ignore Double data records.. and update subsequently update to targets.
Hope this helps..
Regards,
Kalpana M.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi........
Go to the IP Monitor>>Details tab >>Processing Tab>> There expand the erroneous data packet...........there you will get the full error message........
But sometimes the error message does'nt contain the Source system...........In this situation if you are not very sure...........the its better to load the master data for all the source systems............
Regards,
Debjani..........
Edited by: Debjani Mukherjee on Oct 14, 2008 8:40 AM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
95 | |
11 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.