on 10-13-2008 3:11 PM
HI ,
IN PO workflow when release the code workflow started but it showing following error.
No rule defined,
Error in resolution of rule 'AC90100003' for step '0000000002'
(for agent detemination i had used default rules tab).
plsz what is the problem
Check the rule first and simulate it if it works fine. Check the binding and the possible agents.
Regards, IA
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sonu,
The Rule which you created "90100003" is not working properly.
Check whether it inserting blank User id. In simulation you can found easily, while simulation if you get blank User id this will occur, check the variable holding User id is not initial and insert the Value.
Regards,
Surjith
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Check the task that is defined within this step. See if the agent assignment has been done. Try setting it as a General Task. It should work, else as other friends pointed out, it could be binding issues.
Satish
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sonu,
I think this might be a problem with the binding try to bind it again.
Also check out the workflow log in SWIA Transaction to see what exactly the error is \
Thanks,
Chidanand
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
10 | |
10 | |
10 | |
7 | |
7 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.