on 10-13-2008 3:01 PM
Hi all,
I am developing a synchronous senario with fault message both in source and target. In interface mapping how to handle the fault tab? Do i need to give message mapping for Fault message type?
Thanks
Nithya
Do i need to give message mapping for Fault message type?
Yes, it could be message mapping.
Regards,
Prateek
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Yes.. its used in message mapping.
A fault message is a message type used in message interface that describes an application-specific error situation.
Fault message types are designed for application-specific errors that occur on the inbound side and that are reported back to the sender or persisted in monitoring.
In the synchronous case, when an application-specific error occurs on the inbound side, instead of sending a response message back to the sender, the application can send a fault message to handle the error.
http://help.sap.com/saphelpnw2004s/helpdata/en/55/c5633c3a892251e10000000a114084/frameset.htm
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Find below link for more help on fault message
http://help.sap.com/saphelp_nw04/helpdata/en/dd/b7623c6369f454e10000000a114084/content.htm
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
76 | |
9 | |
8 | |
7 | |
6 | |
5 | |
5 | |
5 | |
5 | |
5 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.