number range

[Former Member]

Hi all,

Though we have maintained number range for object J_1IEXCLOC, while saving 'J1IV' transaction, system is giving error message, "error in allocating excise invoice number interval not found", what to do?

Regards,

[former_member581212 · Accepted solution]

hi,

Go to J1I9

Select Number range Object J_1IEXCLOC

Click on Number Ranges and Maintain Number range...

Hope it helps..

Regards

Priyanka.P

[Former Member · Accepted solution]

no, The same thing was already done, but still i am getiing the error.

Regards,

[former_member192897 · Accepted solution]

Go to SNUM trxn code and Input Object J_1IEXCLOC and Click on Number ranges and Maintain the Same.

[former_member529134]

Hello

While maintaining the number range as said by the earlier replies, just make sure that you *maintain the number range with the number range number as 01 only*.

Hope this helps

Regards

Gregory Mathews

[Former Member]

This is also maintained. But I am getting error.

Regards,

[former_member192897]

Check in SNRO for Object J_1IEXCLOC

One more thing check out that number ranges has to start with 01 while defiining.

These are the Possible Reasons for your Problem. Please Ensure everything is Maintained Properly.

[Former Member]

Hi All,

I have checked everything, everything is fine, but I am getting the same error.

Rgds,

[Former Member]

Hi All,

the movement type used 161 for return delivery to vendor and in that excise invoice has been captured. Is this reason for getting the error?

Regards,

[Former Member]

Hi,

Just recreate the number range and then check again

Thanks & Regards,

Amjad

[Former Member]

hi,

That also I have tried. but not working

Regards,