Configuring a UME from a standalone J2EE to Use an AS ABAP as Data Source

[Former Member]

I am trying to configure a UME from a standalone J2ee to use an AS ABAP as Data Source from a double stack. on netweaver 2004 S

MY CRM system is a double stack with an add on standalone J2ee. The standalone J2ee uses the UME database only as data source and the doublestack uses ABAP as datasource.

How do I make the standalone J2EE to use the doublestack ABAP as datasource

[Former Member · Accepted solution]

change the UME configuration from your stand alone J2EE engine to point to the CRM System as th datasource.

Thanks,

GLM

[Former Member · Accepted solution]

I did this but it crashed my Java server and I had to reseting the the UME passwords parameters in service com.core.security.ume and reset that to defaultto hava my java server working again.

[Former Member]

hi,

i have also done it and it worked fine. please follow the below link.

http://help.sap.com/saphelp_47x200/helpdata/en/f0/06093f7c392e5ae10000000a114084/frameset.htm

regards,

jitendra

[Former Member]

Hello Clairie Ndayiziga

The various supported installation scenarios for UME are better described in the SAP Library (http://help.sap.com -> SAP NetWeaver (your version) -> Security -> Identity Management -> User Management Engine -> UME Configuration -> UME Data Sources).

Also please refer the primary SAP Note 718383 - NetWeaver: Supported UME Data Sources and Change Options. This is really very helpful. Actually the data source for UME is decided before/during the installation, since although it is possible to change the data source,it is not recommended, or not possible to perform in some cases. The note will gives you the details of the various scenarios

Hope it will help

Thanks

Dhiraj