on 10-01-2008 9:38 AM
Dear guru ,
It's possible to define a rounding value or a rounding profile
for every material in order to round up the replenishment proposals in MG60 ?
Thanks in advance.
Hi,
In the MF60 transaction goto global setting tab, in the general tab select check box "round up replenishment proposal".
Check it may round up the replenishment proposals
Regards
Vijay
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
closed without solution
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear ,
to round up replenishment proposals at material level using
rounding profile are you using a user exit ?
Thanks.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Vijay ,
i have entered in material master the rounding profile of MRP1 view. But this setting haven't influence in the replenishment proposals of MF60.
Thanks.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Vijay ,
are you sure that rounding profile of MRP1 view influenced replenishment proposals of MF60 ?
Thanks.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
In MF60 transaction it will show collective missing qty with round up in the Mfg storage location area, irrespective of order.
So to round of the collective missing qty we have to activate the round of replenishment qty in the global setting.
Eg: If u assign rounding profile to the material.
suppose
Component A required 100.50 qty against planned order 100 that will be rounding to 101.00
Component A required 150.10 qty against planned order 101 that will be rounding to 151.00
Component A required 250.10 qty against planned order 102 that will be rounding to 251.00
When u go to MF60 transaction then missing qty will be shown as 503.00qty.
If u select the rounding check box in the MF60 transaction and rounding profile is not assign to material,
Then Missing qty in the MF60 transaction is 501.00, means first it will add then round off the sum qty.
If u assign rounding profile in the material master then round off will be done individually.
Regards
Vijay
Dear ,
which type of round up the system execute ?
Can i define a rounding value or a rounding profile
for every material ?
It seems only a decimal rounding defined in CUNI.
Do you agree ?
Thanks in advance
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
There are two ways when u select the check box in the MF60 transaction that rounding of material will take place only in the MF60 transaction.
If u want to maintain it at material level then u have to assign rounding profile to that material.
So when ever u use this material in any transaction rounding profile will get executed.
Regards
Vijay
Edited by: vijay pawadi on Oct 1, 2008 11:43 AM
Hi,
Go to MF60 and press F5 global setting here you will get option round up replenishment proposals .
Regards,
R.Brahmankar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.