Text

[Former Member]

I created a Workorder in R3 via IW31. The status of this Workorder is 1, the text displayed in R3 for this status is "Entered"

I loaded this Workorder into BW via DataSource 0PM_ORDER_ATTR.

I then run Change Run for the 0PM_ORDER InfoObject Master Data.

When I display the Workorder in BW report, the statu of this Workorder is 1, which is correct. However, the text for this status is "Created".

Why? Why it is displayed as "Entered" in R3 but "Created" in BW? Where is this text coming from? Also, I dont see this text in the InfoObject P table.

Please advice, thanks.

Edited by: Linda on Sep 30, 2008 5:32 AM

[Former Member · Accepted solution]

Hi Linda,

Text come from Object: 0STATUSSYS0.

Check what texts are maintained for 1,2,3,4 in 0STATUSSYS0.

From datasource : 0PM_ORDER_ATTR. only attribute(1,2,3,4) comes, text needs to maintained separately. You can change if you want in above object.

Hope it Helps

Srini

[mansi_dandavate]

Hi,

Texts are not present in InfoObject p table, but they are in the Texts table which is the t table.

Check if there is any text datasource for your infoObject 0PM_ORDER_TEXT, then the texts must be coming from that.

Regards,

Mansi