BEx error in 3.x after upgrade to BI7. Cannot save query

[Former Member]

Good day

I hope that someone can give me some guidance in the following: Basis has upgraded BW from 3.x to BI7 and we are busy testing. When I open 3.x BEx I can create a query but when I try to save it, the following error messages display:

1) Program error in class SAPMSSY1 method : UNCAUGHT_EXCEPTION 0.

2) Program GP3VNVKMC51T4VZ6OKX8QL936TA does not exist 0.

3) An exception with the type CX_SY_PROGRAM_NOT_FOUND occurred, but was neither handled locally, nor declared in a RAISING clause 0.

Your assistance will be appreciated.

Thanks

Cornelius

[Former Member · Accepted solution]

This caught us during our upgrade testing (if it is the same problem) - have you got any cmod on variables - did you use EQ rather than BT on range variables?

Check OSS note 911192

[Former Member]

Good day

Thanks for your speedy response. I got it right.... SPRO setting for "Activate personilisation in BEx" was not set. Once set, the error messages disappeared and I could save the query.

Thanks again!!

Cj

[Former Member]

Hi,

It may be due to patch lavel ,the patch lavel should be atleast 7.

Hope it helps.