Skip to Content

Archived discussions are read-only. Learn more about SAP Q&A

Post Installation for PI Usage

We are unable to run the POSTINSTALL steps of technical configuration for the PI usage at the NETWEAVER Administration -> Deploy and Change. As such, during configuration of the PI, there was Integration Server for selection.

We know the reason why the post installation did not successfully completed. The reason was that the SLD was previous pointing to another SLD port 50100. We have since corrected the port (50000) in all the configurations but during this step (POST INSTALL for PI Usage) it still points to the incorrect port.

How can we change the port for this PostInstall process in the Deploy and Change? If not, is there a manual step to complete this operation.

I have include the steps to this error:

(A) Post Installation for PI Usage

1. Start brower http://calypso:50600/nwa

2. Deploy and Change

3. Select "PI_00 This wizard will execute the PostInstall Steps for technical configuration for PI Usage"

4. The Error pops at "Step26/142 Add Installed Product2" (because the port was set to point to 50100 instead of correct 50000). Note that the port was since corrected, and in all configuration for SLD in VA, REP, is all showing correct port number already.

Helpful Answer

by
Not what you were looking for? View more on this topic or Ask a question