Skip to Content

Archived discussions are read-only. Learn more about SAP Q&A

Not able to see Live Cache data in the SNP data view Keyfigures

Guys

I had created a copy of 9ASNP02 Planning Area and had created Planning Book/Data views for this copied PA (similar to 9ASNP94/9ASNP94(1)). I had then added a new key figure to the PA and added it to the data view as well and grouped under Total Demand category. I had also imported the relevant macros from 9ASNP94 PA to this copied PA and then initialized/created Time Series objects.

Now, upon viewing this new data view through/SAPAPO/SDP94, I had observed that the Key figures are not reading the respective LC data as they are being seen in 9ASNP94(1) data view.

One more thing is that in the Keyfigure tab, in the detail section, I had observed that the Keyfigure which I had added to the copied planning book has semantics as 000 (LiveCahce order). However through /sapapo/msdp_admin, PA --> change Key Figure settings, I see this KF having semantics as 000 (Timeseries) and is in a disabled mode and am unable to change it to 000

Other thing I had made sure is that Key figure details such as aggregation, calculation, category, category groups are same as 9ASNP02 Planning Area and am not sure if I am missing some config which enables to see the relevant LC data in these KFu2019s.

Any ideas or suggestions on how to get this issue resolved ?

Thanks

Helpful Answer

by
Not what you were looking for? View more on this topic or Ask a question