Skip to Content

Archived discussions are read-only. Learn more about SAP Q&A

Debugger keeps popping up

Hello everyone,

I keep having problems with the new debugger in a Netweaver 7.0

Sometimes, I have no clue by which rule, I can not properly leave the debugger. I press F8 when debugging my code to leave the debugger. After this each time I save my coding or try to activate I end up in the debugger again, right in the middle of some SAP coding. Only remedy I found so far is to log out and log in again. Restarting the transaction (/nse80) is not working.

To state the obvious:

- I have no break-points in the code I end up in

- I tried /hx to detach the debugger

Has anyone else experienced this? Is there a note somewhere out there?

Regards

Andre

Tags:

Helpful Answer

by
Not what you were looking for? View more on this topic or Ask a question