on 09-25-2008 12:56 PM
Hi together,
I have created a DataSource with rso2 in source system, which is based on a function module. The DataSource works fine, if i test it with transaction rsa3 in source system. But when i request the same data via BI InfoPackage the result differs from rsa3. The number of records is equal, but some columns are initial, although rsa3 lists values in this columns.
Any Ideas?
Hi,
Is there any BI routines as part of the update to the target?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
You have carried out a check in RSA3 and have a set of results. You make a comparison of this result set against your BW results.
Where are you getting the results in BW from, PSA, a DSO, Cube?
In the load path to where you get your results are there any transformations/update rules which are changing the results
>
> Hi
>
> You have carried out a check in RSA3 and have a set of results. You make a comparison of this result set against your BW results.
>
> Where are you getting the results in BW from, PSA, a DSO, Cube?
>
> In the load path to where you get your results are there any transformations/update rules which are changing the results
I get the BW result direct from PSA table via se16.
User | Count |
---|---|
85 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.