on 09-25-2008 5:57 AM
iam working for automative parts.i have asenario where iam loading both radiator assembly & CAC assembly at the same time inside the furance.
normaly sap loads capacity for radiator & CAC one after another.
Dear PP gurus pls help me how to proceed
hi
actually parellel sequece will be used if operation for a same material
but here i have two products which iam loading on the same time at furance and i have finite scheduling. it is just like mix loading in a work center.
i have also found that workcenter basic data view have one field called " mix mat" mostly u have to display this field in cr01 by allowing in field selectionin spro for work center
pls guide
byee
shamba
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear,
Create parallel sequences in routing CA02 so thes two operation will run parallel to each other for same work center.
Regards,
R.Brahmankar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI,
It will effect on scheduling of order.
If there is no finite capacity in work centre or shceduling profile then there will be not any effect on ur capacity.
Please revert back.
Thanks & Regards,
Nilesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.