on 09-23-2008 5:37 AM
Dear Sir,
We are providing material to manufactured optical cble to vander
In this material we required lentgh of optical cble is 500mm so we can feed 500mm qty. in bom of optical cable assy
But vander required 510 mm length of wire because 10mm is used in crimping & soldering. if we put length of wire as 510mm in bom then IQC person verify with bom then at this IQC reject the material .
So pls advice me that where i can put this 10 mm length in BOM so that vander can received 510 mm from us & in CS11 bom display only 500 mm length of wire.
Thanks & Regards
-
Ajay Pareek
Go to change BOM CS02 and Change length from 500mm to 510mm
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
89 | |
7 | |
6 | |
3 | |
3 | |
3 | |
3 | |
3 | |
3 | |
2 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.