on 09-22-2008 12:37 PM
hi experts
when i receive goods for my production order,here comes a problem 'change the inspection stock of material xxx in qm only',i have alreally asigned the inspection type '04' in qm view for the material,does anyone knows how it comes,and how to do
details as follows:
Change the inspection stock of material xxx in QM only
Message no. QA495
Diagnosis
You want to make a stock posting to/from the inspection stock. This is not allowed for material 101001 because the quality inspection control has been activated by QM.
The following cases can occur:
The inspection stock should be increased, although an inspection is not foreseen for the current goods movement
The inspection stock should be released, although you can only do this using the QM transactions.
System Response
You cannot carry out the stock posting.
Procedure
Check both the QM inspection setup data and the movement type for material 101001 in the quality management view of the material master.
Exception:
If you post a return delivery to a vendor with reference to a purchase order, or cancel a goods receipt, the stock indicator from the order is proposed.
Check and modify this proposal as required.
The stock may have been transferred already and is therefore no longer in inspection stock.
Hi,
If you put in QM/MM forums then you will get immdiately proper solution.
Anil
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi
what is process you are doing exactly ,if you have activate the QM then while making the GR for process order system will create an inspection lot ,which result recording should be done and make the usage decision then post the material to stock
can you explain briefly
also you can post QM relevant problem in PLM forum
regards
thyagarajan
hi thyagarajan,
searching lot in qa33 by order,nothing i can found,that means lot lost,well if i set key 03 to the material,when i create order,lot can be found,that means 03 lot is correct,but 04...and if i set 03 and 04 to the material together,just 03 ok,so ,i doult if 04 should be set something special in spro,
User | Count |
---|---|
99 | |
11 | |
10 | |
6 | |
5 | |
5 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.