Component Qty round off in production order

[former_member406212]

Dear all Hi,

I have a ROH material maintained as TON in MM. For calculating the qty required of this component i have maintained the formula in BOM as X factor multiplied with Y factor & divided by 1000 to get the output componenet qty in ton.

Though the system is calculating & displaying the qty in in ton with three decimals but the problem is that system is not giving the EXACT first three digits after decimal.

Example:

(16.08x0.22/1000x49 = 0.173 this should be the output in production order but it is displaying as 0.196

Kindly suggest a solution that system should display the actual first three didgits after decimal as it is.

Thanks in advance.

[former_member406212]

Thanx all

[dhaval_choksi3]

Hi Shaiz,

How the problem is solved ?

Regards.

Dhaval

[former_member406212]

Hi Dhaval

As such the standard SAP supports only 3 decimals in BOM & rounds off the 4th decimal to higher number if it equal to 5 or greater than 5.

regards,

Shaiz

[dhaval_choksi3]

Hi Shaiz,

What are this X factor , Y factor and 1000.And in which condition it change.

Regards,

Dhaval

[former_member406212]

Hi Dhaval Choksi,

X factor is steel length, Y factor is steel diameter and 1000 is to convert in tons. Hope its clear now. Here only X will vary where as Y & 1000 remain costant.

Thanks in advance.

[dhaval_choksi3]

Hi Shaiz,

How the value of that X comes during order processing?Clarify with example.

Regards,

Dhaval

[dhaval_choksi3]

Hi Shaiz,

Check is there any Component scrap is maintain in BOM or Material Master.

I think there is 10 to 15 % component scrap is maintain either it is in BOM or in Material Master (MRP 4)

Regards,

Dhaval

[former_member406212]

Hi Dhaval Choksi,

Thanks for reply.

There is NO component scrap is maintained either it is in BOM or in Material Master (MRP 4).

[rupesh_brahmankar3]

Hi,

Check Decimal places and rouding of decimal place is maintain properly for the base unit of measure of that component in T.code CUNI.

Is there any Rounding value (value = 1) is maintain in MRP 1 data of that component

Regards,

R.Brahmankar

[former_member406212]

Hi R Brahmankar,

Thanks for your reply. There is NO Rounding value (value = 1) is maintain in MRP 1 data of that component.