GATP Product Allocation Data (/SAPAPO/AC42) not updated

[Former Member]

Dear SAP Gurus,

We have an issue right now wherein the GATP Product Allocation Data (/SAPAPO/AC42) not updated after data loading have taken place. We have

a process chain that run that refresh the data in a planning area which

is connected to GATP.

The data where consistent in the between the Planning Area and the Infocube but the GATP still has the old data.

However when the data in Planning Area where save via the Planning Book, thats the only time data in the GATP were refreshed.

Thanks and Best Regards,

Raymond

[Former Member]

it looks like the new data is not overwriting the old data. You can write a macro to Zero out the values of allocation Qty key figure and then you can load the new data from the cube.

[Former Member]

Hello,

Any idea about this issue?

Thanks,

Raymond

[Former Member]

Hi Raymod,

I guess you are loading data into PA from cube through /SAPAPO/TSCUBE - Load Data from InfoCube .Please go to SM37 log of the job and also log on /SAPAPO/TSCUBE and see what is missing ?

Also run the below program and check result again :

/SAPAPO/ATPQ_PAREA_K - Characteristics Combination from Planning Area

Manish

[Former Member]

Hi Manish/ Sai,

Thanks for your feedback. I will perform your suggestion on our Development System and will let you know.

Best Regards,

Raymond

[Former Member]

Dear All,

We have already create a macro to set the affected Keyfigure to Zero, however this doesnt also work.

We have noticed that if we run the macro in backgound, the value of Keyfigure in GATP doesnt change. But if we run in foreground and save, the GATP was also changed.

PLease kindly advise if someone has encountered this issue before. and how to solved this issue.

Thanks,

Raymond