cancel
Showing results for 
Search instead for 
Did you mean: 

Generic Delta Loads

Former Member
0 Kudos

During the delta loads the delta is running fine but the data in the Delta is missing?wat is the solution for this?

Accepted Solutions (0)

Answers (3)

Answers (3)

Former Member
0 Kudos

Hi.......

1 reason may be there is no changed records.....I mean new records......go to the source system and check in RSA7......

If there is 0.......then OK........otherwise some problem is there...

May be delta mechanism is corrupted...

1) Then you first delete the request after making the QM status red..

2) Then delete the Init flag.....IP scheduler >> In the top Scheduler tab >> Initialization options for source system..

3) Then run init with data transfer.......it will set the init flag..

You can also run Full repair with selection.....then init without data transfer.............any one of the two method you can go for..

For full repair .............IP scheduler >> In the top Scheduler tab >>Repair Full request..

4) Then run the delta IP.......

Hope this helps you.....

Thanks == Points as per Forum..

Regards,

Debjani........

Edited by: Debjani Mukherjee on Sep 27, 2008 9:24 PM

Edited by: Debjani Mukherjee on Sep 27, 2008 9:28 PM

Edited by: Debjani Mukherjee on Sep 27, 2008 9:29 PM

Former Member
0 Kudos

Hi Shilpa,

In RSO2 --> Give the datasource name and check the Generic Delta tab and see whether the Delta management has been maintained properly or not.

Regards,

Venkat.S

ravikanth_indurthi
Active Contributor
0 Kudos

Hi Shilpa,

It depends on the type of delta defined and the no. of records updated after the first load.check these files:

https://www.sdn.sap.com/irj/sdn/go/portal/prtroot/docs/library/uuid/84bf4d68-0601-0010-13b5-b062adbb...

https://www.sdn.sap.com/irj/sdn/go/portal/prtroot/docs/library/uuid/10b68b99-022e-2a10-999d-c4dc9ec2...

Hope this helps........

Rgs,

Ravikanth.