Full repair request

[Former Member]

Hi Gurus, I'm going to run a full repair request

Do i need to fill up setup table on the r3 side in order to do the above

Thank you

[Former Member]

How do you execute a Full repair request? I thought I could just do a Full load until I read this post.

Thanks.

Ryan

[Former Member]

Go to the Full Load package

there u will get a option Repai Full Load in the Infopackage Menu

Just Tick mark the Repair Option

[Former Member]

Yes you need data in setup table

Full Uploads and init with data hit setup tables

where as deltas hit delta queues

Full upload with repair is same as full load with the only difference that it is considered like a delta by biw and biw allows delta loads after it.

after a normal full load deltas can not be scheduled.

Regards

Akshay Chonkar

[Former Member]

hmm.

Does that means that i need to run the fill up setup table option again in the r3 now although the setup table contain data from the previous run (a few years back)

[Former Member]

if the data that you indent to extract in the full repair is already present in the setup table through the previous run then no need of running fill setup again.

[Former Member]

oh ok

thanks