on 09-16-2008 2:26 AM
Dear friends ,
Does anyone already have used the new functionlity to transfer material from Storage Location 0001 to Storage Location 0002 under the same plant with STO ?
Which delivery and movement type should I use to do that ? we put a mov. type 311 but errors appear for us.
best regards,
Alessandro
Hi,
Yes when you do the PGI, using VL02N, the movement type will be 641.
Regards
Merwyn
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
I have tested it in 4.7 and it was ok, have not tested in other versions, I suppose it will be through in all versions..
Regards
Merwyn
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Alessandro,
You can very well create an STO keeping the issueing and receiving plant as same and mentioning the issue S.location and do the DO using VL10B and PGI using VL02N.
at the time of GR you can specify the receiving S.location and post the GR.
There is no any requirement for specific config.
Regards
Merwyn
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
pl write the error u get , & as far as the process is concerned for transfering material from one strg. loc. to other strg. loc this can be very well done by T.CODE = MB1B Here u use 311 . But as u wrote about the error , pl give the error so that
Rgds ,
sap11
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
Since its within the same plant there's no need of a STO you can simply use transfer posting with movement type 311.
Regards
Jagadish
Edited by: Jagadish Kumar on Sep 16, 2008 5:47 AM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
101 | |
14 | |
10 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.